1.3 inch Display TFT IPS with ST7789 – 240×240 pixel – SPI
CAD 7.50
Closing for vacation July 16 to August 9.
Discount Type | Quantity | Volume Price |
---|---|---|
Quantity | 3 - 9 | 10% CAD 6.75 |
Quantity | 10 - 24 | 12.5% CAD 6.56 |
Quantity | 25 + | 15% CAD 6.38 |
- Description
- Reviews (1)
Description
Graphic Displays | |||||
Type | LCM12864 GREEN | LCM12864 BLUE | 2.4" Arduino | 1.28" TFT IPS | 1.3" TFT IPS |
LED Backlight | yellow | white | yellow | white | white |
Resolution (Pixel) | 128 x 64 | 128 x 64 | 320 x 240 | 240 x 240 | 240 x 240 |
Interface | SPI, parallel | SPI, parallel | parallel | SPI | SPI |
Controller | ST7920 | ST7920 | SPFD5408 | GC9A01 | ST7789 |
Touch screen | |||||
Part # (Go to) |
1.3 inch Display with IPS Panel and 65k colours connects through its SPI interface with your microcontroller.
The ST7789 TFT display controller requires 3.3V power supply and logic level.
The backlight control pin BLK is low-active.
Please note: The 1.3 inch Display TFT module doesn’t have a Chip-Select pin.
- Module dimension: 28 x 39mm
- Screen dimension: 23 x 23mm
- Mounting holes: 2mm
Like always, libraries for ST7789 TFT (for example for Arduino) are available on GitHub.
1 review for 1.3 inch Display TFT IPS with ST7789 – 240×240 pixel – SPI
Add a review
You must be logged in to post a review.
m.p (verified owner) –
This display is bright, sharp, and has a wide viewing angle (both up/down and left/right).
As the description states, it’s 3.3V, and it’s SPI despite the data and clock pins being labelled SDA and SCL on the one I received. I connected it to a 3.3V Arduino Pro Mini using the following pins:
– GND -> GND
– VCC -> VCC
– SCL -> 13 (SCK)
– SDA -> 11 (MOSI)
– RES -> 9
– DC -> 8
– BLK -> no connection
There are several popular libraries out there that work with this display. It took me a little longer to get it working than I expected but that was because with no CS pin, the SPI mode needs to be set to SPI_MODE2. With that set, it works like a charm!
This display (like many others) is very fragile and will be damaged if it’s not protected. The one I received came in a small plastic box that no longer fit when I soldered the pins on so I cut a small hole in the box so the pins could stick through.
Long story short: it looks great, it’s 3.3V, use SPI_MODE2, and the price is very good.