60W BTL Amplifier TPA3118 (Bridge-To-Load)

Description

This 1 x 60 Watt Class-D Audio HiFi Amplifier board features the Amplifier TPA3118 chip with high efficiency, low distortion and a high signal-noise ratio of about 100dB. It’s configuration is in Mono BTL mode to drive a single speaker on a low operating voltage by achieving high output power with very low distortion.

The recommended speaker impedance is 4-8 Ohms.

A beefy DC power supply of 4.5-26V is required. Depending on speaker impedance and supply voltage, the current consumption can exceed 3.5A. Please refer to the information and diagrams in the TPA3118 datasheet.

Module size is 46 x 35 mm.