Lithium Cell 18650 Charger – 12V Booster – Integrated 18650 Holder
FREE Canada & USA shipping available (see details)
This is a charging and step-up Converter 2-in-1 Module for a single 18650 Lithium Cell with 12V Output to supply power to 12V devices. It provides continuous 12V Output, with the Lithium Cell as a backup for uninterrupted function in case of power loss (disconnecting of the 5V input).
The UPS-Function can be very handy for example to continuous power Programmable Logic Controller or Microcontroller Circuits when the input voltage is unstable or Brownouts/Blackouts happen too frequently.
If 12V output is only required temporary (on demand), a switch can be connected to the pads marked with P5.
To charge the cell, a 5V power supply (min. 1A recommended) must be connected to either the USB port or the 2 pads marked with 5V- and 5V+ right to the USB port.
The 2 solder pads [+] and [-] on the edges in the middle of the PCB are directly connected to the Lithium Cell and can be used to connect our Single Cell Lithium Battery Gauge EAN 4260474034536 (blue) or EAN 4260474034550 (green).
Finally, the 2 solder pads marked with UPS- and UPS+, are the 12V Output. The maximum continuous current available on the output is 350mA @ 12V.
Thre are 3 LEDs on the Module, showing the following information:
LED D2 (green) shows 12V output active
LED D3 (green) shows the full charge state
LED D4 (red) shows the active charging function
Note: Wires and the battery holder need to be soldered to the circuit board. For always-on function, the jumper P4 can be closed with a drop of solder.
Specification: Lithium Cell 18650 Charger – 12V Booster – Integrated 18650 Holder